What is an RC High-Pass Filter? - RC High-pass equations:
The basic components used in fabricating the filter are resistors, abbreviated as R, and capacitors, abbreviated as C. RC high-pass filter circuit. The output is taken across the resistor after the input signal is given across the series combination. This filter enables passages of high frequency, above the cutoff frequency (fc), while restraining low frequency sound systems.
How to Calculate Cutoff frequency?
The cutoff frequency (fc) is where the output signal power drops to half (or -3dB) of the input power. It is given by:
For Example, Resistor R = 2KΩ (2000Ω), Capacitor C = 12µF
How to Calculate Capacitor?
The capacitor is where the out-signal power drops to the power. It is given by:
For Example, Desired cutoff frequency fc 1 khz (10000hz), Resistor R = 10KΩ (1000Ω)
How to Calculate Resistor?
The Resistor is where the out-signal power drops to the power. It is given by:
For Example, Desired cutoff frequency fc 10 Hz, Capacitor C = 47µF
What is an RL High-Pass Filter? - RL High-pass equations:
An RL high-pass filter is created from a resistor (R) and an inductor (L) connected in series. This output is taken across the resistor after the input signal is given in the combination of the two resistors. At higher frequencies, the output signal of the resistor traverses through it, while the inductor output signal confines the same at lower frequencies.
How to Calculate Cutoff Frequency Formula:
The cutoff frequency (fc) is the frequency at which the output signal is reduced to 70.7% of the input signal. It is given by:
For Example, Resistor R = 30Ω, Inductance L = 200µH
How to Calculate Inductance?
The inductance is the inductor at which the output signal is reduced to the input signal. It is given by:
For Example, Desired cutoff frequency fc = 1khz (1000Hz), Resistance R = 1KΩ (1000Ω)
How to Calculate Resistor?
The Resistor is where the out-signal power drops to the power. It is given by:
For Example, Desired cutoff frequency fc = 2khz (2000Hz), Inductance L = 200µH
Suggested Reading
- Resistor Capacitor voltage divider Calculator
- LED Parallel Resistor Conversion Calculator
- series Capacitor Conversion Calculator
- Resistor Voltage divider Conversion Calculator
- Resistor capacitor time constant conversion calculator
- Capacitor Resistor voltage divider calculator
- Parallel Inductors Conversion Calculator
- Resistor Inductor voltage divider calculator
- Capacitor current divider conversion calculator
- Series Resistor total Conversion Calculator
- Resistor wattage conversion calculator
- op-amp low-pass filter conversion calculator
What is an RC High-Pass Filter?
A resistor (R) and a capacitor (C) connected in series are used to construct the resistor-capacitor high-pass filter. The output side is taken across the resistor after the input box signal is supplied across the series circuit combination. Depending on the cutoff frequency (fc), this filter circuit allows higher frequencies to flow through while blocking low-frequency sound systems.
RC High-Pass Filters conversion application
- Audio signal processing to remove bass frequencies.
- AC coupling to block DC components.
- Data communication systems to eliminate low-frequency noise.
RL High-Pass Filters conversion application
- Audio filtering to remove low-frequency noise.
- Power supply noise reduction.
- Signal shaping in communication circuits.